RAM Aluminum iFinder and Atlas Strap Base Mount

The RAM Marine Grade Aluminum Rail Strap Mount consists of the 1'' dia. ball and socket system with RAM Plastic Cradle for the Lowrance iFinder Series and Brunton Atlas.

RAM-B-108-LO2U BASE DESIGN:
The Powder Coated Marine Grade Aluminum Rail Strap Mount Base fits a rail diameter from 1.0'' to a maximum of 1.9''. The 1'' rubber ball is at a right angle to the mount base placing the ball at a right angle to the rail.

To mount this base, first place the 'U' Shaped plate on the rail and then wrap the metal clamp strap around the rail and plate. Tighten the screw knob on the metal strap with a screw driver until the strap has a firm hold on the rail.

Included with the base is one 6.0'' and one 8.0'' long metal strap is included with this base along with a 5.5'' long (approximate) strip of rubber to avoid any scratching or marking of your rail.

RAM-B-108-LO2U ARM DESIGN:
The Powder Coated Marine Grade Aluminum Standard Length Double Socket Arm is 3.0'' long when measured between socket centers.

RAM-B-108-LO2U CRADLE DESIGN:
The RAM high strength plastic cradle is designed to hold the following GPS units,
• Lowrance iFinder
• Lowrance iFinder Atlantis
• Lowrance iFinder Plus
• Lowrance iFinder Express
• Lowrance iFinder Pro
• Lowrance iFinder Pro Plus
• Lowrance AirMap 500
• Brunton Atlas

All cables can stay connected to the unit while in the RAM cradle. American-Tiger is your one-stop shop for the latest in ram mount technology, and always check out our Super Deals on Garmin, Magellan, Lowrance & Auto Nav Electronics !

PLACING YOUR GPS INTO THE CRADLE:
Place the bottom of the GPS into the cradle, and then lay the GPS back into the cradle. The top of the cradle will snap around the top of the GPS unit.