The RAM Plastic Rail Mount consists of a locking tooth system with RAM Plastic Cradle for the Garmin eTrex Series.

RAP-274-GA5U BASE DESIGN:
The High strength Plastic Rail Mount consists of a locking tooth system with a standard RAM diamond plate end. The mount will fit a rail diameter from 1.0'' to 1.1''.

To mount to a circular rail, simple press the plastic 'U' clamp around the rail and then connect and tighten the small nut and bolt to close the 'U' clamp. Next connect the diamond plate to the mounted clamp at the required angle and screw in the other bolt through the diamond plate. Now you are ready to connect any of the RAM Plastic HOL Cradles or any other cradle with two holes positioned 1.912'' center to center.

Placing a rubber lining (not included) between the tube and the mount for a tube with a diameter less than 1'' will help the base 'grab' the rail.

NOTE: You cannot rotate the diamond plate on the 'U' clamp when the cradle is connected.

RAP-274-GA5U CRADLE DESIGN:
The RAM high strength plastic cradle is designed to hold the following GPS units,
• Garmin eTrex Series
• Garmin eTrex Camo Series
• Garmin eTrex Summit Series
• Garmin eTrex Venture Series
• Garmin eTrex Legend Series
• Garmin eTrex Vista Series

All cables can stay connected to the unit while in the RAM cradle. American-Tiger is your one-stop shop for the latest in ram mount technology, and always check out our Super Deals on Garmin, Magellan, Lowrance & Auto Nav Electronics !


PLACING YOUR GPS INTO THE CRADLE:
Place the bottom of the GPS into the cradle, and then push the top into the expandable 'arms' at the top of the cradle. The 'arms' will snap into place when the GPS is completely in the cradle.

RAP-274-GA5U Ships With:

	RAM-HOL-GA5
	Diamond Plate with Rail Mount

RAP Plastic eTrex Series Bike Handlebar Rail Mount (RAP-274-GA5U)
RAP-274-GA5U, Garmin eTrex, ram mounts, American-Tiger