RAM Plastic Garmin GPSMAP 176/176C/196/276C/296 Unit Cradle

ram mounts, American-Tiger, RAM-HOL-GA7U

The RAM High Strength Plastic Cradle is designed to hold the following GPS units,
• Garmin GPSMAP 176
• Garmin GPSMAP 176C
• Garmin GPSMAP 196
• Garmin GPSMAP 276C
• Garmin GPSMAP 296

All cables can stay connected to the unit while in the RAM cradle.

PLACING YOUR GPS INTO THE CRADLE:
Place the knob of the smaller side arm of the RAM cradle into the hole in the back of the GPS. Now slide the larger arm around the edge of the GPS unit until the end of the arm 'clicks' into place at the front edge of the GPS unit.

INCLUDED WITH THE CRADLE:
The cradle includes a set of two nuts and bolts to connect the cradle to any of the RAM compatible mounts.

IMPORTANT MOUNTING INFORMATION:
If you already own the cradle shown above, or any other cradle with a hole pattern that will match the RAM Diamond Plate hole spacing, then you require one of the RAM Assemblies listed below. If you are looking to purchase a complete mount for the above cradle, take a look at the Complete Mount list below.

The cradle does not ship with a RAM ball. To add a 1'' ball to this cradle you need to purchase either the Aluminum Diamond Plate with 1'' ball (RAM-B-238) or Plastic Diamond Plate with 1'' ball (RAP-B-238). If you need to mount this cradle on a 1.5'' ball system, you will require the Aluminum 2.5'' diameter Round Plate (RAM-202) as RAM does not make a Diamond plate in the 1.5'' ball size.

RAM Plastic Garmin GPSMAP 176/176C/196/276C/296 Unit Cradle RAM-HOL-GA7U

ram mounts, American-Tiger, RAM-HOL-GA7U